Welcome to MM4x4, your 4x4 partner. Tel: 01905 451 506. Order online and receive 5% discount* (See T's & C's). Family run since 1950.
Series II and III Moulded Acoustic Matting System
Series II and III Moulded Acoustic Matting System
Series II and III Moulded Acoustic Matting System
Series II and III Moulded Acoustic Matting System
Series II and III Moulded Acoustic Matting System

Series II and III Moulded Acoustic Matting System

£477.60
Bookmark and Share
Information
The kit is available for Series IIs & IIIs standard gearbox
 
Series Acoustic Moulded Matting System (not V8, Lightweight or 6 Cylinder)

This is the only front matting system available that is approved by Land Rover and the Ministry of Defence. This is the Kit. Already fitted to most military Land Rovers and used in extreme environments, this kit has proved itself to be up to the job time and time again. Supplied as a 3 piece kit with the floor & tunnel in one piece with the seat box totally covered and the bulk head centre. Approved at Millbrook testing ground and reduces the noise and heat levels in the front to below required safety standards.
The Grey Moulded Matting System has been specifically designed to increase ride comfort by greatly reducing heat and road noise. The 3 piece matting system is manufactured entirely from black cast dense polyurethane using precision injection mould tooling.
The Grey floor mat is a one piece floor section that covers the driver's / passenger's foot-wells and the gearbox tunnel. This design feature ensures maximum soundproofing and heat suppression.
The Grey one piece seat box cover encases the 3 open sides of the seat box to also greatly reduce noise and heat. Once the supplied firewall section is installed sound and heat reduction will be drastic.
 
Some trimming is required when installing the Grey Moulded Matting Systems. The kit is also supplied with a bulkhead panel and the seat box cover is one piece and will require specific fitting.
 
Key Features:
 
Water repellent - Flame retardant- Black spec - Supplied as a 3 piece kit - Extra thick cast rubber on average 1/2" thick - The whole mat is one piece from one side to the other - The bulkhead section is simple to install and is held in place by floor section - The driver's and passenger's foot well have noise suppression foam panels underneath - The seat box section is also one piece and will require cutting to suit your particular vehicle.
 
Specifications
  • Brand:
    Exmoor Trim
  • Product Code:
    EXT009-11BK
  • Weight:
    25kg
Reviews
product review overlay image

Customer reviews

No reviews left yet
Write a review

No reviews have been left for this product, be the first to leave a review